跳转到内容

Template:TLS-RL/doc

维基百科,自由的百科全书

Usage

{{TLS-RL}} 和{{TLS-PL}} 必须同时使用。

{{TLS-RL|NoPL= <!--number of payloads defined (MUST be the same as number of {{TLS-PL}} templates used below)-->
|date =    <!--launch date (GMT)-->
|time =    <!--launch time (GMT)-->
|rocket =  <!--type of rocket used-->
|flight =  <!--flight number-->
|site =    <!--launch site and pad-->
|LSP =     <!--launch service provider-->
|remarks = <!--notes, anything else that is not covered-->
|payload = {{TLS-PL <!--add one of these templates for each payload-->
  |name =     <!--payload name-->
  |cubesat =  <!--"yes" if this is a CubeSat, empty for larger satellites-->
  |user =     <!--payload operator-->
  |orbit =    <!--orbit regime or "suborbital"-->
  |function = <!--function of the spacecraft/mission-->
  |d-date =   <!--decay date, omit if still in orbit or not yet launched-->
  |d-time =   <!--decay time, omit if still in orbit or not yet launched-->
  |outcome =  <!--outcome (successful, failed, partial failure, ongoing, etc), leave blank before launch-->
  |d-span =   <!--see below-->
  |o-span =   <!--see below-->
  }} <!--there should be NO LINEBREAK if a further {{TLS-PL}} template is added-->
}}

The d-span and o-span parameters can be used to apply the same decay date and outcome to different payloads on the same rocket. If a number is entered, then that field will be applied to that many consecutive payloads (including the one for which it is specified). If it is set to "inherit" then it will inherit from the cell above. If it is not set to "inherit" but a span is specified above, then it will cause a syntax error. The d-span parameter should only be used where the payloads will be attached during re-entry/landing, and o-span should only be used in the event of a total launch failure.

See also